school bus window delete

Thanks for the info BusFiend. Believe it or not, a simple razor blade will get you far when it comes to removing decals.

So I pulled a window today and think I figured out how I am going to cover these windows. Some people have suggested retaining them as white "off road" lights but in Massachusetts I'd have to cover them with opaque covers on the highway and I didn't want the bother. That puts my mind at ease. Insulated windows are offered with radius or … This tool is also versatile because it’s great for removing sticky residues in general. If you’re interested in seeing the process of how we removed our decals, make sure to check out the video below and subscribe to our YouTube channel for more videos on the bus conversion process. Hello, I am rather new here and just recently purchased a bus for my own conversion project. Additionally, they’re all versatile tools that can be used for various different projects in your bus conversion. This site has been an awesome resource so first off, thank you. Bus Exterior, Seating, and Window Screens: Exterior: I decided to completely remove the flashing lights on the front of the bus. The top two thirds is a bay window with a very strong cross bar and the last third is the slider that also can be used as an escape window. One of the very first things you can do on a bus conversion is remove the decals. Don't worry about the aluminum adding weight. That being said, this would be a great tool to have in your arsenal for many reasons because of its versatility. Here are three different methods you can use to remove them from your school bus.However, heat guns can be used for a lot of different things, such as drying out damp wood, thawing frozen pipes, removing old paint and softening adhesive. The most recommended for Bus-RV conversion is the "T" slider window as in these images.

Razor Blades. Further, except for buses equipped with rear push-out emergency exit windows in accordance with S5.2.3.1(b), school buses shall not be equipped with both sliding and push-out emergency exit windows. Windows outside/wall inside. saw this on another conversion project. 1.

It takes a little extra time and elbow grease, but they get the job done. It's lighter than both steel and fiberglass. school bus conversion project. Here are three different methods you can use to remove them from your school bus. Where some people would prefer one of these methods over the other, we’d recommend having all three because depending on the application, one may work better than the other. 2. foam insert sized to window, fiberglass the sides and exterior, screw edges into frame, and again bondo seams and edges. So I pulled a window today and think I figured out how I am going to cover these windows. So if you use any adhesives or remove windows that leave a mess behind, the rubber eraser wheel makes for very easy cleanup.In summary, all of these are great options. It seems like a simple task but those decals have likely been adhered to your bus for quite some time. It does take a little more elbow grease, but could also be a great option to clean up the adhesive left behind after using a heat gun. 3. keep the windows and clean & seal them up, paint the interior black, and fill with foam insulation and plywood wall. S5.2.3.3 The engine starting system of a bus shall not operate if any emergency exit is locked from either inside or outside the bus . I didn't know that about aluminum being lighter than fiberglass.